If you are not competent in commissioning a CNC controller and its associated parts, this product is not for you. All warranty claims require return to base at the buyer's expense for assessment, which can take 3–4 weeks. Warranty will not be honoured for issues caused by the purchaser.
The Proma Compact THC SD is a plasma torch height controller with STEP/DIR inputs and outputs instead of relay outputs. It is based on the Proma Compact THC 150, and sits between your CNC controller and the Z-axis stepper driver.
Until the cutting arc is detected, the Z-axis STEP and DIR signals from your CNC controller pass straight through to the driver. Once the main arc is detected and the delay time has passed, the THC takes over the Z axis. It then generates its own step/dir correction pulses to hold the set arc voltage, and so the torch height, as the sheet warps or slopes. Because it works independently of the software, it suits control systems that have no THC function, and any controller that drives the Z axis with STEP/DIR signals.
The voltage divider, HV/HF pilot-arc protection and filtering are built in. It accepts either the plasma cutter's full raw arc voltage or the 1:50 divided-voltage output found on most major brands (e.g. Hypertherm Powermax45). It is factory configured and works with most plasma cutters once connected.
Specifications
- Model: Compact THC SD (Step/Dir PID generator)
- Supply voltage: 7–35V DC, max input current 120mA, isolated switching supply
- Arc voltage input: raw arc voltage up to 300V DC, or 1:50 divider input up to 10V DC
- HV/HF pilot-arc voltage elimination: yes
- STEP/DIR inputs and outputs: TTL 5V
- Pass-through signal frequency: 100kHz
- Correction signal frequency: 0–5kHz
- Duty cycle: 100%
- Protection: IP20
- Size: 33 × 89 × 65mm, 130g, DIN35 rail mount
Settings (two-key LED display)
- Voltage setpoint: sets the torch height
- SPE: Z-axis correction speed (output clock frequency)
- d-t: arc delay time 0.1–9.9s (factory 0.5s)
- H-U: arc detection voltage 50–300V (factory 200V)
- tSt: test mode, simulates arc voltage so you can check the wiring without cutting
- dir: reverses the Z correction direction
Install it as close to the plasma source as possible, using the shortest practical arc-voltage leads. Connect the STEP/DIR signals with shielded cable, with the shield grounded at the CNC end only.
Download the Compact THC SD operation manual (PDF)
Need relay up/down outputs instead? See the Proma THC 150.